3D-Print Logo Keychain w/ NFC

I have a clean logo file that I’d like transformed into a small plastic key-chain. My plan is to 3D print it on an FDM printer and pause the print at the correct layer so I can drop in the NFC sticker I already have on hand, then let the print finish and seal it inside. Here’s what I need from you: • A printable 3D design based on my logo that looks good at key-chain size and leaves a neat recess for a standard round NFC coin (25 mm diameter, 1 mm thick). • The finished STL plus a ready-to-run G-code file (PrusaSlicer or Cura is fine) with a programmed pause at the exact layer where the recess starts. • A quick note in the file or message stating the layer height and the precise layer number so I can pause manually if needed. Dimension guidance, filament type, or any other details you need—just let me know once you see the logo. I’ll approve the final model by test-slicing it on my end before we wrap up.